Graphical LCD Breakout Board
Last updated: 28 Apr 2012 - 18:35
Working Display: Display showing the OSHW logo as a demo.
I've got an on-going project to build a battery powered device. I want to be able to run the whole thing at 3.3V so I can easily and efficiently run it off a single LiPo cell. I also want to use a simple monochrome, graphical LCD for this project, but I couldn't find one that would run off 3.3V. For various other reasons, the project requires that the LCD is a classic 8bit parallel module as I had run out of hardware serial ports and bit-banged was making the refresh seem really slow. I found a few that would run the control lines off 3.3V but still needed some higher voltage to power the screen or back-light. Eventually I bit the bullet and decided to go with one of these from Farnell because it was the cheapest back-lit 128 by 64 pixel display I could get from them. It is a really good choice as it even includes electronic contrast control, something I was expecting to have to do in external circuitry. However, it isn't a nice 0.1" pitch module, it comes out to a 0.5mm pitch FPC connection.
OSHW Logo for Kicad PCB Milling
Last updated: 01 Mar 2012 - 21:38
I've been tinkering with some simple PCB layout jobs in KiCAD over the last couple of weeks. (Hopefully they'll be worth posting here if I can get them finished!) One of these boards is probably going to be cut out on a PCB mill, so it's not going to have a solder mask or silk screen. I wanted to still have the Open Source Hardware logo, there's a big selection available at http://www.oshwa.org/open-source-hardware-logo/ including downloadable modules for KiCAD but they're all silk screen logos, so I went about creating a copper only logo.